Here's your stock titan with the shell removed, you can see the stupid amount of complexity that was introduced in order to provide the integration for the Scout and Hornet, there's also one more idiotic item to this gun, a ball-barring based restriction that doesn't allow the gun to fire if it's tilted up too far. I have no idea why this was even put in.

Justin's 1st branding. Done the 1st day my cautery machine came in the mail actually.

At this scale, adding wing cannons or weapons of any type would've spoiled the overall shape. This was a compromise.

Here you see the beginning of the 5-barrel shell, the barrels must be glued in this star pattern in order to fit into the shell casing. You can use a piece of 1/2" FBR in the center to keep things measured out.

good old one

new recessed wheels

Carriage 'Tambo' sits in the loco shed at Maldon while having one end modified into a platform like 'Yarra'. 20th June 2004.

Took a flight from Auckland to Nelson and drove the beast to Waihi.

The antenna atop the upper hull behind the dome got some work. I replaced the little plastic knobs with glass beads glued to short sections of music wire. The main support shaft was replaced with music wire as well. The only plastic left is the main ball. This makes the antenna much less likely to break off any of it's tiny bits when I'm handling the model.

All that yellow staining? Gone! Using Magic Sponge and elbow grease :)

String the pieces together. Hubby helped :D (those are hubby's hands)

anti rotation clips from BikeFun

This is after the grind

1930's-40's Police Car

Firstly, I needed to shorten the overall length. The only section of straight pipe was these small 'silencers' so I decided to remove them.

I took out the baffle with the 10" Eminence speakers and replaced it with a 12" Celestion Vintage 30.

i think it looks much better now!

This is a modification of LEGO official set 60227 - Lunar Space Station.

rebrickable.com/mocs/MOC-35059/beewiks/lego-frame-space-s...

Image taken 27.05.2012 by David Moth..Raisbeck Modifications on this C90B include twin spin strakes & extended wing luggage lockers

After hours of serious EMC-analysis and measurements, we nailed down the noise problems to a bandwidth problem. A harmonized low pass filter removed almost al of the disturbances.

It was later implemented on the circuit board.

ETF

I TIG welded a new piece of aluminium into the hole in the coolant channel. This was my first time TIG-ing Ali and cast ali is the hardest due to all the impurities and the difficulty with the heat conducting away so quick.

I'm pretty pleased with the result visually though have no idea how strong it is. It only has to contain the coolant pressure rather than having any real structural significance.

After it is sufficiently hollowed out, coat the bottom in epoxy and stuff it in the barrel.

The top hose connection was achieved with a 45 degree and 90 degree hose tilted backwards

Photos from our trip though a greenhouse for doing SCIENCE!

Blog: www.whatisthescience.com/exploring-science/scientific-gar...

I stripped the electronics, added a John East Sweepable Mid controller as well as series/parallel switchrs for each pickup. she sounds amazing!

I bought a kit from a guy in the owners club that consisted of a bunch or blue LEDs, a blue gel for the clock and a set of instructions. An hour or so later the job was done.

All work copyright the artist © Philip Wallace

My Nike Air Dual D II shoes, post-op, sock liner removed. Beneath the initial cloth layer, there was some light foam, 1/8 (approx) inch thick. When that was taken out, it wasn't deep enough for the chip, so I continued to slice into a soft rubber layer, about 1/4 inch thick until I reached the sole, seen here. I sliced into one of the air pockets accidentally.

Wien Mitte