View allAll Photos Tagged welding
hand held welding hood resting and scrap steel resting on the pallet that will hold the pulled IC engine till the project is done (i.e. IC engine sold)
The 2017 SkillsUSA National Leadership and Skills Conference Competition Medalists were announced Friday, June 23, 2017 at Freedom Hall in Louisville.
Welding Sculpture
Jonathan y Watson
High School Cumberland County Regional Technical Education Cen
Gold Vineland, NJ
Welding SculptureSamuel Rishel
High School Sun AreaTechnical Institute
Silver New Berlin, PA
Welding SculptureCalvin Tohm
High School Spearfish High School
Bronze Spearfish, SD
Welding SculptureErin Beaver
College Penn College of Tech
Gold Williamsport, PA
Welding SculptureSeth Cromer
College George Stone Center
Silver Pensacola, FL
Welding SculptureBri Bader
College Anoka Tech College
Bronze Anoka, MN
Page 47.
On the left, the structure model sits on the floor in front of Marco.
In the middle, the model is up on the table- a part being added.
On the right, the finished structure model.
Marco told me on the phone that it is the left ankle of the 40 foot version.* It was stress tested yesterday, using a fork lift this time. The other stress test was done with a truck:
www.flickr.com/photos/doneastwest/3954056562/in/set-72157...
The pipe and braces at the top are temporary.
LAST PAGE OF SET 01 ON BLISS DANCE ( Colossus ).
See the other sets here:
www.flickr.com/photos/doneastwest/sets/
___
* - i suppose this could be the first useable piece of the finished sculpture, but made from measurements. The usual way to make full size parts will be to measure up from plaster, 3 foot, sections, but they are not made yet.
Later- this piece was kept as a model. the left ankle was built again.
Another one for the eyes this week… welding safety! Welding sparks and the light emitted can quickly damage your eyes if you are not wearing the proper gear. If you notice somebody welding, be sure to keep your eyes away until they are finished. Also, be aware of surrounding surfaces that can bounce hazardous light into your eyes. If you are the welder, do your best to let others know you are welding. If you can, set up the welding walls around you to block the light and proper vacuums to ventilate the fumes. Don’t forget to wear welding gloves, the materials you are welding can be extremely hot and damaging if they enter your pores.
---------------------------------------------------------------------------------------------
Gompf Brackets, Inc. - Mukilteo, Washington
915 9th St.
National Register 1/9/1978, 5WL.567
"Designed by Denver architect William Norman Bowman this impressive four-story building of Indiana limestone and marble was completed in 1917. Its Neoclassical design is unique in the Greeley area"--Description from the History Colorado website.
ورشة النادي العلمي 6\10\2010
All rights reserved to FableQ8 (Abdullruhman Al-khamis)
It is strictly prohibited using images without the permission in writing from the person FableQ8 (Abdulrahman alkhamess)
Otherwise, you will be legally justiciable
Simple fitment of welding glass (plus graduated ND filter here) using a mounting ring for a slot in filter holder plus 3 spring clips. For just the welding glass, a single clip at the top usually works ok, but can let a bit of light leak in around the edges.
The Weld Boat House faces out onto a curve in the river. It houses the shells used by the intramural and women's intercollegiate crews. (The shells for the men's crews are in the Newell Boat House, upstream on the other side of the bridge.)