Svitare a mano la calotta

More on my blog: luca.yepa.com/blog/2007/03/05/howto-manutenzione-del-winch/

After coloring around the pinhole with the sharpie marker it's time to remove all the masking tape. Your pen painting should be darker than mine as the marker I used was not very dark.

Slide the aluminum disk around until the pinhole is centered in the 1/4" drill hole.

Diagram indicating how the octahedral configuration is built.

Someday, I'll be able to add an arrow which says "x20" and not just "x8" :)

I followed rhapsodie's internet recipe and made some great cookies for the solstice bonfire today.

secure.flickr.com/photos/valette/2117497292/

www.galeteria.cat

Switch wired up...

Packed into a small plastic bin with a lock-fitting lid.

Still missing:

- earplugs

- toothpaste

- sunscreen

- lip balm

Build in 1651 previous under catholic regime but later changed to reformist

Levare le leve a scatto. Attenzione a non perdere le molle.

More on my blog: luca.yepa.com/blog/2007/03/05/howto-manutenzione-del-winch/

Outside, or with adequate ventilation, paint over the aluminum disk so it is black.

串好横孔水滴

www.comixology.com

[Design Solutions]

Dall'interno del corpo del winch smontare i cuscinetti a sfera

More on my blog: luca.yepa.com/blog/2007/03/05/howto-manutenzione-del-winch/

More on my blog: luca.yepa.com/blog/2007/03/05/howto-manutenzione-del-winch/

© Copyright Eric Johnson 2020 Unauthorized use Prohibited

Build in 1651 previous under catholic regime but later changed to reformist

The adhesive should look like this when applied.

Round off the corners of the square so there are no sharp edges to cut yourself.

1 3/4 cup of flour

1/2 cup of sugar

1 pinch of salt

3 pinch of turmeric (curcuma)

mix dry ingedince well

1 egg

3/4 cup of butter, or whole fat margarine

( optional one spoon vanilla flavor)

kneed until dough is smooth. add tabelspoon of water if needed. form a roll and cut into 1 inch pieces. lay the cut side down on a lightly greased cookie sheet and squash them with a fork. bake at 350f for 8 to 12 minutes, or until golden. ( and smelling good)

The PVC pipe is schedule 40. This way the pipe will break before human bones.

Dando un colpo e' possibile far uscire la chiave

More on my blog: luca.yepa.com/blog/2007/03/05/howto-manutenzione-del-winch/

After the dimple is sanded away a small hole should appear in the aluminum. Use the needle once more to gently round out the hole (both sides).

I used a paint marker (you could use a small paintbrush) to draw in the "coloring book lines" on top of my white areas.

HOWTO is here: www.maxsons.org/index.php/2067