View allAll Photos Tagged sensor
I am trying my sensor in my arm for the first time. It hurts a little but I suspect that will go away soon.
Used the sensor swab to clean the big clingy pieces of dust off of my ccd. Couldn't get them all though.
Picture taken at 50mm f:22, over a white roof. PP whit Camera Raw to show dust spot more crearly.
The picture was flipped to show the sensor as seen from the lens bayonet in a way to make easier the clean up.
Some very big spot on the right center side.
Shenzhen Liangjian Electronic Technology Co., Ltd. is a 10years old professional sensor custom manufacturer that provide quality Car seat pressure sensor which includes good quality, performance and service as well. For More Visit:- ljcircuitprint.com/portfolio_category/car-seat-pressure-s...
Wide operating temperature range: -40 to +250Celsius degree
Dielectric strength: 1,500V AC for one second
Short thermal response time in water, high stability in moisture
Suitable for use in low and high-temperature and moisture environments
High accuracy,Different tolerancr available ,Cost-effective
UL approval ,RoHS compliant
Climatic category:IEC60068-1
Resistance tolerance :+/-1% to +/-5%
Insulation resistance: Greater or equal 100Mohm
Dissipation Coefficient: 3-10 mW/Celsius degree in still air
Time constant : 3-15 Seconds in hot water
Moisture resistance:(40Celsius degree 95% RH)1000 hours
Recommended Applications
1.Temperature measurement in household appliances:
Water heater,Water boiler,Dish washer ,Toaster, Soybean milk maker.small appliance
2.Temperature sensors for industry control
Website: www.sensor-manufacturer.com/
If you order back up sensors online there are many companies that may even offer you free shipping. There are many different types and brands of back up sensors and doing some comparative shopping for the best price on sensors is smart. Do not neglect getting back up sensors any further.
I knew the sensor on my 40D was dirty but damn I had no idea it was that bad! Good thing I have a new set of dust-aid cleaners on the way.
Selects of Foy Vance & Trevor Sensor performing at the Troubadour
Hollywood, CA
09/23/16
More Highlights:
Creo que tengo el sensor lleno de polvo, ah no son pajaros ¡¡¡
I think that i have the sensor full of dust, oh no they are birds ¡¡¡
Parking Management System
Brief PM910F is a Luxury series Parking Management System for managing high-grade pay-to-park facilities with high traffic flow, for both occasional and registered parkers. This system automatically dispenses ticket for occasional parkers, and registered parkers get access and leave by self-service swiping their cards on entrance & exit controller
www.automobileindustryindia.com/xiamen-dashou-technology-...
Trying to reverse engineer how toy sword circuits detect a swing motion and do not trigger for a tilt motion, using only two cheap tilt switches installed perpendicular to each other. Am going to place some tilt sensors on a board in various orientations, wire them to LEDs, and swing the board while watching the blinking LEDs for a pattern.
Before I do this experiment, my hypothesis follows: Software loop detects state change on tilt_sensor1 and starts a timer. Timer will count down to zero then stop, setting a flag. If tilt_sensor1 state changes again, the timer is restarted.
If software loop detects a state change on tilt_sensor2 AND the timer flag is cleared (timer is running), then swing is detected.
Timer length will be adjusted for sensitivity.
To a visit at the “Leica Leitz-Park“ in Wetzlar (Germany).
The home from my Leica 😍📷
Additional information:
- OoC-JPEG
- Film mode: Standard (sharpness = medium high)
- Colour space: Adobe RGB
- Exposure mode: M
- Exposure metering: Multi point
- Focus: Manual
- Handheld