Open up the cut fabric, it should resemble the shape above.

Everyone should have a pair of furry leg warmers, of course. They can also double nicely as a pair of boot covers. I just whipped up a pair for Halloween.

by : marcustegtmeier.com

Film stills of a howto podcast with Julie Schneider!

Part of my tutorial on (re)stretching a canvas!

how to fold an origami paper crane

Paso N°1: Hervir agua.

Como preparar El Mejor Mate Cocido en 5 pasos fáciles

Tutorial

Coffe types

bend the legs downwards.

Lo primero es tomarse la foto en una postura adecuada sobre un soporte discreto

上下のフタに切れ目を入れます。

※フタの折り目まで！本体は切らない。

Because of the way we had our lumber cut, we ended up with a spare piece of board which we had cut to be slightly smaller than the headboard (28") and we used this scrap wood as an additional support beam in the middle of the headboard. This scrap plank was attached just as in Steps 6-8. This is likely an optional step.

A how to build an indoor hanging wall garden.

Position the bag on the pad, then lower the lid and press firmly.

Pick a front-center of the flower, and attach an embellishment. I used a handful of gold seed beads.

popapp.in

[Design Solutions]

via Tumblr ift.tt/W8ks3A

ift.tt/1trsQaL alot of people succed with this diet. you can do it to! ift.tt/1trsQaL fat burning meal plan for men diets for quick weight loss fat…

muscle building tips

via Blogger ift.tt/W8LdFk

A little crafty tip to bring the pattern back:

missniff.blogspot.com/2010/03/how-to-revive-pattern-on-fe...

最後のフタは、最初のフタの下に折り込みます。

Requires phantom power. Also shown is the popper stopper.

XLR connection on the mixer (commonly called a 'board')

sammenligner metode til at røre dej til hvedeboller, samme mel, gær, vand, surdej og hævetid i køleskab. Kun forskellig metode: 1) uden røremaskine, ælte et par gange i løbet af nogle timer versus 2) normal hurtig 5-10 minutter æltning med røremaskine.

raaberg.blogspot.dk/2012/08/fantastisk-grydebrd-utrolig-n...

How to make this costume

Removing the pinion from the motor shaft had inadvertently pushed the magnet down the shaft, causing it to be slightly loose, instead of fixed to the shaft.

This caused a piercing squeel when the motor was under any load.

No squeeling without any load, so you wouldn't think there was a problem with the motor until it had to drive something with resistance.

The cut is flat and de-burred.

Attaches, colles et collants double face. Le plus simple étant de prévoir du double face épais pour coller directement sur la surface.

now add some more of the wire's insulant to the legs. instead of two colours you could leave a gap like spiderbot1 or use heatshrink (which I might try on my next spider).

Sand all lumber, wiping down with a damp cloth. Be sure to sand the corners and anywhere else that might be a snag-hazard.

According to the directions on the wood stain, give your boards several coats of stain, allowing 2 hours of dry time in between coats. Then apply at least two coats of Polycrilic sealer according to the directions, allowing to dry in between. This is a two day process!