View allAll Photos Tagged modification
Using the wiring diagrams, CAREFULLY locate and separate the required wires.
Disconnect the car battery before attempting to cut any wires.
I removed the distrating tree away, with the use of Cloning Stamp in Photoshop. Gosh! I thought that wouldnt be hard doing that! but it took me 2 hours to complete it! (Of course including a few games on Zuma Blitz on Facebook to rest my eyes, eventhough the game didnt actually help much!)
the original one with tree on the right top corner
and did another one with just cropping the tree away.
hmmm~ I do think the cropping makes the photo a bit to tight? however, the two focused flowers pop out! hmm! such a dilemma!
In this photo you can see where I've had to weld an extension on to the rear bracket to raise the side rail height. The fixings to the cant rail have also been raised.
Sir Humphrey: To put it simply, Prime Minister, certain informal discussions took place involving a full and frank exchange of views, after which there arose a series of proposals which on examination proved to indicate certain promising lines of enquiry, which when pursuit led to the realization that the alternative courses of action might in fact, in certain circumstances, be susceptible of discreet modification, leading to a reappraisal of the original areas of difference and pointing a way to encouraging possibilities of compromise and cooperation which if bilaterally implemented with appropriate give and take on both sides might, if the climate were right, have a reasonable possibility at the end of the day of leading rightly or wrongly to a mutually satisfactory resolution. (Yes, Prime Minister)
#3 of 3
photograph © Stephanie Fysh 2006; all rights reserved
Washkewicz College of Engineering students, faculty, staff and alumni enjoyed a day turning donated, battery-operated toys into ones that kids of all abilities can enjoy.
The hood frame side rail has been moved up by approx. 20mm on the front and the back to clear the door glass.
bored out the backside of the barrel adjuster hole (past the threads) to 7/16" and filed a little ramp to help the cable carrier slide easily around inside of there.