View allAll Photos Tagged HowTo,
Sand all lumber, wiping down with a damp cloth. Be sure to sand the corners and anywhere else that might be a snag-hazard.
According to the directions on the wood stain, give your boards several coats of stain, allowing 2 hours of dry time in between coats. Then apply at least two coats of Polycrilic sealer according to the directions, allowing to dry in between. This is a two day process!
Setup for: flickr.com/photos/johnmclellan/sets/72157612300799176/
How I mount three flashes on my umbrella.
Three flashes in an umbrella means your refresh rate is much faster than a single flash. 1 hour photo shoot with each firing at 1/16 I could sustain a rate of about 2 shots a second, with bursts of up to three. 400 shots no problem.
See notes!
I used a pre-folded double fold bias tape to create the bound edge on these placemats. There are several ways to attache the binding, I pinned mine in place and sewed straight down, making sure that the thread was correctly sewing on both the front and back of the placemat.
Step by step guide to set up Iris scanning on Samsung galaxy S8 phone. Other security feature is Face recognition & Fingerprint scanner on galaxy S8 device
Interior of brake drum. This shows the bolt heads that go through the brake drum, the plate, and the floor flange holding it all together.
in order to connect the battery's -ve terminal use some wire with insulant still on and hot-glue it in place. you should try and make the battery removable while at the same time make sure the battery won't fall out if vibrating or turned upside-down.
My image titled VAST was created from two images. Here I've shown on the left what the SOOC image looks like when exposed based on enough light to see the valley below. I rotated the SOOC shot 180 degrees making it appear I was above the clouds or in Space. Then I added the SOOC moon shot and voila!