View allAll Photos Tagged Help
It's a disaster!! I was playing with panoramic photomerge. This is merged from a series of scanned photos from my pre-digital days. I guess most of the picture looks ok but the sky is all messed up. The healing tool is not working out. Any tips would be greatly appreciated. Thanks in advance!! :-)
Spraying epoxy primer is a process that requires careful preparation and safety precautions. Here's a step-by-step guide to help you through the process:
Materials:
Epoxy primer
Primer activator (if required by your specific product)
Spray gun
Compressor
Clean rags
Wax and grease remover
400-grit sandpaper
Tack cloth
Personal Protective Equipment (PPE) – respirator, safety glasses, gloves
Steps:
Clean the Surface: Before you begin, clean the surface you'll be spraying thoroughly with a wax and grease remover. This will remove any oils or residues that could prevent the primer from bonding properly. Wipe the surface dry with a clean rag after cleaning.
Sand the Surface: Lightly sand the surface with 400-grit sandpaper. This will create a slightly rough texture for the primer to adhere to, improving the bond. Wipe the surface with a tack cloth after sanding to remove any dust.
Mix the Primer: Some epoxy primers require you to mix the primer with an activator before use. Follow the manufacturer's instructions for the correct mixing ratio.
Prepare the Spray Gun: Fill the spray gun with the mixed epoxy primer. Set the correct pressure on your compressor - typically around 10 to 20 PSI for siphon guns or 25 to 30 PSI for gravity feed guns, but always check the manufacturer's recommendation.
Safety First: Put on your PPE. This should include a respirator, safety glasses, and gloves at minimum. Epoxy primer can be hazardous if inhaled or if it comes into contact with skin.
Spray the Primer: Hold the spray gun about 6-8 inches from the surface. Spray in a steady, even motion. It's better to apply several light coats than one heavy coat. Allow each coat to flash off (become slightly dry to touch) before applying the next. Typically, two to three coats are sufficient.
Cure the Primer: Allow the primer to cure fully before sanding or applying any paint. This typically takes 24-48 hours, but can depend on the specific product and environmental conditions.
Always follow the specific instructions provided by the manufacturer of your epoxy primer, as these can vary. It's also critical to work in a well-ventilated area when using epoxy primer due to the strong fumes.
HELP! Why is my canary bald??? She sits in a sunny position, has plenty of vitamins in the form of broccoli, fruit pieces and has calcium from her cuttle fish. I use a mite spray in her cage and clean it every week. She has a regular bath.
Why is she losing feathers? What am I doing wrong??????
I saw this the weekend of June 24th on Saddle Mountain in NW Oregon. Any ideas on what this flower is?