View allAll Photos Tagged latching
Magna Latch Round Post Adaptor will allow a Magna Latch Top Pull or Vertical Pull to a round latch post and gate frame. Each kit supports a variety of post and gate frame sizes.
The latch is on a spring that allows for opening to put the borer into the chuck and then closes up against the large-to-small transition. The latch is a tricky part; originally it was made with spring steel but that was too soft and rounded over eventually, not capturing the increment borer. I had these made from regular strap steel and so far have proven far more resilient.
The latch opening goes from full round diameter to reduced round diameter of the borer shaft. This allows for very quick removal and placement of the drill attachment to an increment borer.
The dancers ripple and billow the fabric of the skirt until it seems that the dancer in the center will be swallowed up by the troubles that are drowning her.
The Spring-Latch locks the mount when folded to travel as well as when it is raised in operating position.
I drilled holes on a line, parallel to, and 4-1/2 inches from outside edge. Fore hole is 1-1/2 inch from front edge, aft hole 1 inch back. This is contingent on your hatch's placement relative to the front edge of the lip / curb / coaming. Measure carefully!
Not bad for a Prosumer/Point & Shoot camera. Love how the bee latches on to the leaves of the flower. This was taken in my back garden :)
This owl was named after my baby Eli! He's my beagle/lab mix (or something). I used earthy colors in this one and I love how the blue stands out!
I used vintage/thrift-store bought yarn and canvas! I try to use what's already been produced before I go to the yarn stores!
It's for sale at
Title says most of it. The finding of it did, however, explain the idea of pulling the pin to allow someone in.
This is an old latch hook rug.
It's not antique, it's old though, probably 1960's (give or take a decade....sorry...I don't know.)
in addition to the 4 corner latches, the center of the cover is latched as well. This view is the left side of the bed approximately in the center. There is a bar that slides along the bed rail that hooks into the bracket when the cover is completely closed.