View allAll Photos Tagged hinge
For any further information visit our website or contact us:
OCM Industrial Doors Srl
Via Mongilardi, 3
13900 Biella Italy
Tel.: (+39) 015 . 840 83 01
Fax: (+39) 015 . 849 26 60
Gps: N 45°32'52'',E 8°02'55''
A detail from the Victorian door. A little TLC wouldn't come amiss but you can still see the elaborate and completely OTT workmanship on the door hinge.
Detail from a St. Marys, Kansas Shed. And no, I wasn't holding the camera crookedly--the shed had a decided lean to it.
Cast Iron strap hinges for doors become an elegant abstract pattern in this photo. The variety of shapes, sizes and patterns, but the replication of shapes and motifs keeps the photos interesting. Parts from HouseofAntiqueHardware.com
Early - mid March, 2010.
Hinge time!
Since the doors would be coming off anyway, the hinges needed lots of attention.
The upper was a GM replacement which was rusty, but reusable (left picture). It has good bushings, so it will be just sanded, wirebrushed, and painted.
Skuzzy would not begin to describe the lower one (right picture). This will take quite a bit of elbow grease, new pin & bushings and new hold-open roller…
A complete overhaul so to speak.
First, the door panel and all small parts were removed from the door. Kick panel and door sill were removed and an old towel covered the floor to protect the new carpet.
After disconnecting the battery, the power lock and speaker wires were cut and pulled into the door. The lock wires got a set of connectors attached to their ends, and the door side got their mates.
The garage was cleaned enough to make up a safe area for the door once it was removed. Lots of carpet and padding was used to protect the paint.
The door edges and fender edges were wrapped in masking tape to protect from chips. A sharpie pen was used to mark the hinge locations for easier reassembly. Alcohol will remove the marks later.
After supporting the door well and removing the bolts from the door, and keeping a firm grip on it, it came off without issue. When the last bolt came out, I slid the door rearwards to clear the painted area. I lifted the door, kicked the stool away, and set it on the ground. Not bad for a one man job…
I marked the hinges ont he frame side and removed the hinges.
Wow! These were tough. You would never imagine that a hinged door would be that difficult. But it was.
Ornate iron hinge on the south door of All Saints, Wing.
Photos of All Saints parish church in Wing, Buckinghamshire.
For more information follow this link to the heritage gateway:
www.heritagegateway.org.uk/Gateway/Results_Single.aspx?ui...
Bartels USA offers Tectus hinge, invisible hinge, hidden hinge, and concealed hinges available in stock.
Heavy Duty Kason 1277T strap hinge used for walk-in coolers and freezers with large over-sized doors.
Backbone is extruded aluminium, brass hinges screwed into pre-drilled holes in that. Points of the screws cut off at the back of the plywood.
Isn't as wonky as it looks here, the joins are parallel and actually quite sturdy.