View allAll Photos Tagged Howto
On my blog is a description and how to make your own whiteboard soooo much better than those smudgy boring whitboards.
Situazione dei freni davanti prima di iniziare l'operazione
More on my blog: luca.yepa.com/blog/2007/03/23/howto-cambio-dei-pattini-de...
This shows a signal stream received by BTM-182 going into arduino RX (top), and the response from arduino (echoing) TX to BTM-182 RX (bottom).
Sew a small piece of felt to the back of the flower, so you can slip a hair clip of brooch pin into the flower and interchange it as desired. Be sure to only sew two sides of the felt, as shown.
Set the prints in a drying rack. The Gocco rack works best for postcards, but seems to work ok for lunch bags.
- peel and chop up a butternut quash into chunks
- roast at 350 in glass pan with one chopped up sweet onion and one chopped up head of garlic, covered in 1 cup stock & one T olive oil
- Stir once during cooking
- Cook in 3-5 cups stock for 20 minutes on simmer
- Add 1 T butter (optional) & salt and pepper to taste
- Blend
- Serve with roasted walnuts and sharp cheese
The XLR adapter allows two XLR mics to be connected for better quality audio recording than the on-board mic.
For one light-up LED: a sewable coin cell batter holder, a CR2032 coin cell battery, a small sewing needle, (optional) needle threader, 16" conductive thread, a sewable LED, and craft scissors. PLUS something to sew your electronic components to (like a felt wristband)!
For two light-up LEDs: All of the above PLUS another sewable LED and about 8" more conductive thread, depending on the distance you need to sew.
For 2+ light-up LEDs that twinkle: All of the above PLUS 1-2 more LEDs (8-16" more conductive thread) and a LilyTwinkle or LilyTiny chip.
{Tutorial: Framing a Pegboard That's Already On the Wall with Moulding }
Attach moulding with finishing nails. We found it easier to pre-hammer the nails into the moulding, and then place the moulding against the wall and finish hammering.
Be very careful to line the moulding up correctly, especially at the corners.
Hurray! Here it is! Part 3 of my step-by-step guide to covering your journal over on this chicken's blog.