View allAll Photos Tagged 3dPrinting
some warping... it is colder now, and that should help with the heat-creep, but now I will have to work harder to avoid warping :(
I setup a pcduino3 to run pronterface. But it couldn't handle a model with this complexity, not enough memory. But what kills me is that the Replicator would happily print something like this from SD card... with a fraction of the RAM. Why does pronterface have to be such a memory hog?
Back to stupid Windows on my netbook again.
Ultimately I plan to use www.astroprint.com/ with the pcDuino3. But it is as yet unreleased.
I still need the pcDuino3, though, as I connected a PowerSwitch Tail to it, and using the gpio drivers I can turn off the lulzbot from remote if it jams again while I'm off-site.
#howlsmovingcastle #3dprinting #3dmodeling #painting #miyazaki #ilcastelloerrantedihowl
3Dprinting: @fabio_pirri73
Painting: “Inika’s Things”
I'd been trying to print her at a 45 degree angle so that the front surface wouldn't be marred by supports and so that I could print her all at once and as big as the Replicator could manage.
But the smaller cross-sections lodged in the support were shrinking away from the support material, so I put her as flat as I could.
Here you can see that MakerWare's concept of "maximum" scaling does not so much allow for the gunk barriers. And that the Replicator itself is happy to print past the edges.
3Dprinting
3D printed on Objet Connex 350
mady by Institute of Polymer Product Engineering
at Johannes Kepler University Linz / Austria
These are from dutchmogul's Breach preview part 2: www.thingiverse.com/thing:38360
I love the design on these guys. I want to cut this in netfabb and make it into easily ToM printable cuts for a 3x to 4x sized build.
3D printed on Objet Connex 350
mady by Institute of Polymer Product Engineering
at Johannes Kepler University Linz / Austria
3Dprinting, 3D printing, 3D-printing
Working with the new Raspberry PI 4 for the last few videos, I have continued to develop the custom 3D printed case as well. The base and cover are beefed up. The legs latch into place. All the ports are available.
Chihuahua is all set to roll on 3D printed prosthesis - See more at: www.3dprintersonlinestore.com/chihuahua-is-all-set-to-rol...
Print all your favorite #emojis ! Which one would you print? #3dprint #3dprinting #future #technology #tech #innovate t.co/PhdoolZh9H via Twitter twitter.com/3dprint3dprint
So, this happened! The super talented Joy Complex made a 3D printed Robot Skull charm from one of my doodles! Check it out and pick one up here - j.mp/1IANhdJ