View allAll Photos Tagged 3Dprinter
Anycubic Mono 4K - 1st Print - Cones of Calibration - 1st Fail - 17-07-2022
Printer: Anycubic Mono 4K
1st Print EVER!
File Name: Cones of Calibration
1st Fail
Print Date: 17-07-2022
Resin: Anycubic Water Washable (Stinky! offensive to be in room)
Power: 50%
Slice: 0.08
Setting Default as per Photon Workshop
Normal Exposure: 2.00s
Off Time: 6.50s
Bottom exposure Time: 40.0s
Bottom Layers: 6
Anti-alias: 1
Surface Abrazine: off (frosty effect I think)
The UV Power was turned down as everyone says to do this to prolong screen life. Screens cost more then the printer did no inclined to do this.
Temp: 21°C Humidity 78%
Result: a blasted failure where about 0.5mm printed and the print itself just failed as the raft was well stuck to FEP.
Had to drain the tank and filter the resin which was messy but I had the lab stand and filters which helped. Really need a longer stand pole to clamp a vat holder to.
I managed to get the print fail from the FEP by wiggling with finger underneath and careful lifting with plastic spatula. FEP possible scratched by paper tower used to wipe resin.
It was attached to the Build plate before separation and binding to FEP as can be seen from the lines on the Resin print itself.
The washer pinning the thermocouple has been clipped to prevent wedging the thermocouple out. If your insulator is conductive, as is the case with flat graphite gasket tape, insulate all electrical connections with kapton tape or other high temperature insulator. These electrical connections are not.
X axis is a piece of an old TV stand and a kitchen drawer slider. Y axis is rack and pinion from old printer and a drawer slider from an old desk. The Y motor is mounted on a radiator bracket!!
歡迎英語花園與Tree Maker合作舉辦了【科技小達人】夏令營~
上午學習3D列印和機台，下午學習軟體製作創意時鐘！
期待週五拿到時鐘喔~
-
璇兒老師、Sam老師、Zibra老師、阿戴老師與英語花園老師們
-
歡迎各級校院與安親補習班與我們聯絡喔~
Tree Maker, Make you stronger！
---Tree maker 3D printing Center---
聯絡地址︰30272新竹縣竹北市嘉豐六路二段146號
連絡電話：886-3-6682899
官方網站：http://www.tree-maker.com/
#treemaker3d #3dprinting #englishgarden
Print all your favorite #emojis ! Which one would you print? #3dprint #3dprinting #future #technology #tech #innovate t.co/PhdoolZh9H via Twitter twitter.com/3dprint3dprint