View allAll Photos Tagged microcontroller

Note that it must be oriented properly. One of the two pieces of metal inside the LED has two little circles in it; that piece of metal should face to the right, the one without holes to the left. Make sure the legs on top are flat against the top of the wood; there will be a gap between the bottom of the wood and the legs underneath it.

Microchip's MRF89XA transceiver has extremely low receive current of 3 mA for longer battery life in 868, 915 and 950 MHz Sub-GHz wireless networks. For additional information, please visit Microchip’s online Wireless Design Center at www.microchip.com/get/D2C7.

  

Sanguino is an open source Arduino-compatible microcontroller board that is based on the Arduino, and inspired by the Boarduino form-factor. It uses the atmega644P chip which has 4x the memory, ram and 12 more GPIO pins than the Arduino's atmega168.

 

More info: make.sanguino.cc/1.0

 

The MC13224 from Freescale is a ZigBee System-On-Package device. The three dies pictured are the microcontroller, radio, and flash memory.

Shrimp low cost microcontroller kit I got from Cefn Hoile at OSHcamp :-) shrimping.it/blog/

Yet another side project; A while back I designed PCBs for a relatively simple persistence of vision top; This is the top board, with the microcontroller and some sensors.

 

these boards were sent out to Laen a while back, should be coming back any day now.

Pixel VGA, version 1 (Floor Cluster) - Garnet Hertz

 

Two dozen old computer monitors occupy the center of a gallery floor in a cluster facing the wall. Each screen is controlled with custom electronics to create pulsating and strobing patterns, casting a colored wash across the darkened gallery.

 

Dimensions: Variable (approx 3m x 3m). VGA monitors, custom electronics. 2011.

 

More project information: conceptlab.com/pixel/

Infineon XMC 2Go

 

KIT_XMC_2GO_XMC1100_V1

 

Summary of Features:

XMC1100 (ARM® Cortex™-M0 based)

On-board J-Link Lite Debugger

(Realized with XMC4200 Microcontroller)

Power over USB (Micro USB)

ESD and reverse current protection

2 x user LED

Pin Header 2x8 Pins suitable for Breadbord

The circuit design behind my 2009 valentines day card to my sweetheart. Incorporates 1 AVR ATTiny45 microcontroller driving 2 constant-current shift registers driving 16 LEDs.

 

http://www.synopticlabs.com/blog/?p=31

 

Talks and performances by people doing strange things with electricity

Fri 23 March 2012, 6.30-10pm with interval at the Showroom Cinema, Sheffield.

 

Dorkbot is a meeting of people interested in electric/electronic art in the broadest sense; robotics, kinetic art, microcontrollers, interactive art, algorithmic music, net.art... The only real conditions are that it is a bit strange and involves electricity in some way. It is really defined by whoever turns up, be it engineers who want to be artists, artists who want to be engineers, or the otherwise confused.

 

This MEGADORK event features a cabaret of talks and performances from among the UK's dorkiest, to entertain and amaze:

 

Paul Granjon - A strange performance from the world renowned self-styled robot artist.

www.zprod.org/

 

Patrick Tresset - Talks about his drawing robot Paul (on show as part of the Alan Turing: Intuition and Ingenuity exhibition).

www.aikon-gold.com/

 

Daniel Jones and James Bulley - talking about generating live music from patterns of weather.

www.variable4.org.uk/about/intro

 

Sarah and Jenny Angliss - playing robot music from past futures.

spacedog.biz

 

Sergi Jorda - talks about the Reactable tangible tabletop music playground (which you'll be able to try out at the Central Library Saturday 24 March)

www.reactable.com/

 

Dan Stowell - Demonstrates his use of the Risset illusion in techno music.

www.mcld.co.uk/

 

Silicone Bake - Live coded pop songs about love, death and counterfeit watches, where all lyrics are taken from spam emails.

 

Megadork is curated by Alex McLean.

 

Dorkbot started in New York, spread to London, and now dozens of cities around the world, including several active UK chapters; Sheffield, Bristol, Anglia, Newcastle, Cardiff and Alba (Scotland). Find out more at: www.dorkbot.org

 

Lovebytes 2012 - Digital Spring

A Festival of Art, Science and Technology

22-24 March

Sheffield UK

 

www.lovebytes.org.uk

Microchip Technology achieved certification for its ZigBee® RF4CE Compliant Platform, which enables the next generation of RF remote controls and consumer electronics. The platform consists of Microchip’s nanoWatt XLP eXtreme Low Power PIC® microcontrollers, the MRF24J40 IEEE 802.15.4 transceivers and FCC-certified modules, and the industry’s smallest memory footprint ZigBee RF4CE certified protocol stack. For more information visit: www.microchip.com/RF4CE

CNC USB Controller - JCNC

more Information: www.jtronics.de

Sanguino is an open source Arduino-compatible microcontroller board that is base

 

Sanguino is an open source Arduino-compatible microcontroller board that is based on the Arduino, and inspired by the Boarduino form-factor. It uses the atmega644P chip which has 4x the memory, ram and 12 more GPIO pins than the Arduino's atmega168.

 

More info: make.sanguino.cc/1.0

 

Sanguino is an open source Arduino-compatible microcontroller board that is based on the Arduino, and inspired by the Boarduino form-factor. It uses the atmega644P chip which has 4x the memory, ram and 12 more GPIO pins than the Arduino's atmega168.

 

More info: make.sanguino.cc/1.0

The MPLAB® ICD 3 is a cost-effective, high-speed in-circuit programmer and debugger for Microchip’s Flash-based 8-bit PIC® microcontrollers (MCUs), and its entire line of 16- and 32-bit MCUs and 16-bit dsPIC® Digital Signal Controllers (DSCs). Please visit www.microchip.com/ICD3 for more information.

David presents an interfacing Arduino and Adobe Flash. Dorkbot crowd makes up a quick game called "Busy Proctologist" using some craft items, a pressure sensor, and the goatse image.

 

The crowd concluded after finding a latex glove, a styrofoam ring, some bubblewrap, and some red and brown felt, and a pressure sensor that the game would be called "Busy Proctologist."

 

Gameplay involves "examining" as many patients in the day as possible (measure by a 1 minute timer in Flash) without causing undue discomfort during the rectal exam (exceeding a moderate pressure range measured by the sensor and arduino.)

 

Two Nikon SB800 flash units controlled by an Arduino microcontroller. Triggered by a piezo sensor on the air gun.

Thx for assistance and location to Jürgen Stemper // Bloemche

The PIC32 USB Starter Kit II (part # DM320003-2, $55) is an upgrade of Microchip’s existing USB starter kit for Microchip's three new PIC32MX5/6/7 families of 32-bit microcontrollers. For more info visit www.microchip.com/PIC32.

How to make a single-sided circuit board. Read more about this project here.

How to make a single-sided circuit board. Read more about this project here.

Motorcycle gear shift indicator

CNC USB Controller - JCNC

more Information: www.jtronics.de

Microchip Technology Inc., a leading provider of microcontroller, analog and Flash-IP solutions, today announced the expansion of its RF power amplifier portfolio, with the addition of the new SST12LP17E and SST12LP18E devices. The SST12LP18E is a lower-cost, lower-voltage alternative to Microchip’s popular SST12LP14E power amp.

The finished LED daughter board. The left-hand end of the header plug has been cut off so that it'll fit the DIN 41612 connector on the AVR motherboard.

 

Microchip Technology Inc., a leading provider of microcontroller, analog and Flash-IP solutions, today announced the expansion of its RF power amplifier portfolio, with the addition of the new SST12LP17E and SST12LP18E devices. The SST12LP18E is a lower-cost, lower-voltage alternative to Microchip’s popular SST12LP14E power amp.

The rectangle in the middle is 18x64 pixels.

Version 1.1 of our open source 'tiny2313 breakout board. Read more here.

Talks and performances by people doing strange things with electricity

Fri 23 March 2012, 6.30-10pm with interval at the Showroom Cinema, Sheffield.

 

Dorkbot is a meeting of people interested in electric/electronic art in the broadest sense; robotics, kinetic art, microcontrollers, interactive art, algorithmic music, net.art... The only real conditions are that it is a bit strange and involves electricity in some way. It is really defined by whoever turns up, be it engineers who want to be artists, artists who want to be engineers, or the otherwise confused.

 

This MEGADORK event features a cabaret of talks and performances from among the UK's dorkiest, to entertain and amaze:

 

Paul Granjon - A strange performance from the world renowned self-styled robot artist.

www.zprod.org/

 

Patrick Tresset - Talks about his drawing robot Paul (on show as part of the Alan Turing: Intuition and Ingenuity exhibition).

www.aikon-gold.com/

 

Daniel Jones and James Bulley - talking about generating live music from patterns of weather.

www.variable4.org.uk/about/intro

 

Sarah and Jenny Angliss - playing robot music from past futures.

spacedog.biz

 

Sergi Jorda - talks about the Reactable tangible tabletop music playground (which you'll be able to try out at the Central Library Saturday 24 March)

www.reactable.com/

 

Dan Stowell - Demonstrates his use of the Risset illusion in techno music.

www.mcld.co.uk/

 

Silicone Bake - Live coded pop songs about love, death and counterfeit watches, where all lyrics are taken from spam emails.

 

Megadork is curated by Alex McLean.

 

Dorkbot started in New York, spread to London, and now dozens of cities around the world, including several active UK chapters; Sheffield, Bristol, Anglia, Newcastle, Cardiff and Alba (Scotland). Find out more at: www.dorkbot.org

 

Lovebytes 2012 - Digital Spring

A Festival of Art, Science and Technology

22-24 March

Sheffield UK

 

www.lovebytes.org.uk

This is an ARM board that I got for free. No idea what I'll do with it, long term, but it packs significantly more punch than an Arduino.

 

Currently investigating the wild world of toolchains (this is invaluable for OS X). Once I can compile and upload the sample apps, how about getting an RTOS running on it?

Testing out an ADXL335 accelerometer, and interfacing it to an AVR microcontroller. Read more here

The PIC16F1934/6/7 are the first microcontrollers featuring Microchip Technology's enhanced Mid-range 8-bit core.

8-Bit microcontroller with EEPROM

Four Arduino microcontroller boards delivered.

The Z8 was a microcontroller introduced by Zilog in 1979, competing with the Intel 8048. Note that the Z8 is entirely unrelated to the better-known Z80.

 

This is the side of the QUIP package that is down (toward the printed circuit board) when inserted into the socket. On each side two staggered rows of contacts are seen. The legends are printed on the kovar lid which seals the die cavity. The on-centerline oval and off-centerline round hole match plastic posts in the socket used for keying.

 

Note that Intel labeled their QUIP parts on the other side, along the probe contacts, so that the labeling was visible when the part was socketed.

 

For more info on ceramic leadless QUIP:

www.brouhaha.com/~eric/retrocomputing/quip/

Lissajous figures are interesting curves that occur in systems where oscillation happens in more than one direction, for example when a pendulum hanging from a string moves in the plane.

 

These pictures are from an easy persistence of vision approach to playing with Lissajous figures. Read more about this project here.

  

Closeup of the power connections.

Pixel VGA, version 1 (Floor Cluster) - Garnet Hertz

 

Two dozen old computer monitors occupy the center of a gallery floor in a cluster facing the wall. Each screen is controlled with custom electronics to create pulsating and strobing patterns, casting a colored wash across the darkened gallery.

 

Dimensions: Variable (approx 3m x 3m). VGA monitors, custom electronics. 2011.

 

More project information: conceptlab.com/pixel/

Talks and performances by people doing strange things with electricity

Fri 23 March 2012, 6.30-10pm with interval at the Showroom Cinema, Sheffield.

 

Dorkbot is a meeting of people interested in electric/electronic art in the broadest sense; robotics, kinetic art, microcontrollers, interactive art, algorithmic music, net.art... The only real conditions are that it is a bit strange and involves electricity in some way. It is really defined by whoever turns up, be it engineers who want to be artists, artists who want to be engineers, or the otherwise confused.

 

This MEGADORK event features a cabaret of talks and performances from among the UK's dorkiest, to entertain and amaze:

 

Paul Granjon - A strange performance from the world renowned self-styled robot artist.

www.zprod.org/

 

Patrick Tresset - Talks about his drawing robot Paul (on show as part of the Alan Turing: Intuition and Ingenuity exhibition).

www.aikon-gold.com/

 

Daniel Jones and James Bulley - talking about generating live music from patterns of weather.

www.variable4.org.uk/about/intro

 

Sarah and Jenny Angliss - playing robot music from past futures.

spacedog.biz

 

Sergi Jorda - talks about the Reactable tangible tabletop music playground (which you'll be able to try out at the Central Library Saturday 24 March)

www.reactable.com/

 

Dan Stowell - Demonstrates his use of the Risset illusion in techno music.

www.mcld.co.uk/

 

Silicone Bake - Live coded pop songs about love, death and counterfeit watches, where all lyrics are taken from spam emails.

 

Megadork is curated by Alex McLean.

 

Dorkbot started in New York, spread to London, and now dozens of cities around the world, including several active UK chapters; Sheffield, Bristol, Anglia, Newcastle, Cardiff and Alba (Scotland). Find out more at: www.dorkbot.org

 

Lovebytes 2012 - Digital Spring

A Festival of Art, Science and Technology

22-24 March

Sheffield UK

 

www.lovebytes.org.uk

CNC USB Controller - JCNC

more Information: www.jtronics.de

1 2 ••• 33 34 36 38 39 ••• 79 80