View allAll Photos Tagged 3dprinter
These are some items from either Issue 32 or 33, I believe.
World control panel, and awesome buttons.
Still waiting on some more parts (PLA bushings, RAMPS electronics, heated print bed and a few other little things) but the frame is built and is solid. Opted for the 'army green' for the printed pieces...turned out pretty nice.
They do some 'print on demand' service using these. They sold one of these and I spoke with the excited new owner while I was in there.
Three webcams aimed at front, left, right - all with a slight upwards tilt. For an autonomous vehicle
Still waiting on some more parts (PLA bushings, RAMPS electronics, heated print bed and a few other little things) but the frame is built and is solid. Opted for the 'army green' for the printed pieces...turned out pretty nice.
Removed 3 Stepper Driver boards, replaced with a Pololu Stepper Motor Driver board - freed up 2 power connectors, cleaned up a lot of mayhem.
Still waiting on some more parts (PLA bushings, RAMPS electronics, heated print bed and a few other little things) but the frame is built and is solid. Opted for the 'army green' for the printed pieces...turned out pretty nice.
Dual Spiral Lightbulb Sculpturehttp://www.thingiverse.com/thing:24646
More details on challenge here:http://forums.reprap.org/read.php?282,137052
Timelapse at:https://vimeo.com/44103338
Print took 00:36:19
; generated by Slic3r 0.8.2 on 2012-06-15 at 13:03:50; layer_height = 0.3; perimeters = 2; solid_layers = 3; fill_density = 0; nozzle_diameter = 0.5; filament_diameter = 1.75; extrusion_multiplier = 1; perimeter_speed = 35; infill_speed = 60; travel_speed = 130; extrusion_width_ratio = 0; scale = 1; single wall width = 0.70mm
Still waiting on some more parts (PLA bushings, RAMPS electronics, heated print bed and a few other little things) but the frame is built and is solid. Opted for the 'army green' for the printed pieces...turned out pretty nice.
A Prusa i3 3D printer in action.
This printer was built, and is operated, by two high school students.
“Before you print, please adjust the distance between the nozzle and platform, to avoid scratching the kapton tape in the platform. Please check the way from the in the SD card.”
This is the latest picture of my 3d printer. clearly not very far but i'm trying to improve the quality of the parts so everything is nice and square - which is also why i abandoned the mendel design and went back to the square design darwin uses. other than looking at the blender 3d model of mendel, i've not looked at any other 3d printers.