View allAll Photos Tagged 3dPrinter
Printed at various infills. These were stopped before being completed. .5 infill on the right, .3 on the left.
Pololu Stepper Motor Driver, relay board, stepper driver v3.3 board (for MK6 Stepstruder) and some custom cabling. I have to print some mounts and clean this up.
It also contained two filament spools:
• White ABS 1.75
• Translucent Blue PLA 1.75
Spools are smaller than usual:
• Outer diameter:
• Inner diameter:
• Weight:
This is my father's bot, re-built. New wood, painted (inside is gloss white). Has blue and red LEDs, and the X / Y stage is printed in fluorescent red ABS.
Has a MK6 extruder, Gen 3, PSMD, etc.
Still waiting on some more parts (PLA bushings, RAMPS electronics, heated print bed and a few other little things) but the frame is built and is solid. Opted for the 'army green' for the printed pieces...turned out pretty nice.
Three webcams aimed at front, left, right - all with a slight upwards tilt. For an autonomous vehicle
This is a roughly 60mm dodecahedron printed on our latest MakerBot prototype. The z-stage is a bit wobbly, but the rest of the build quality is nice.
The bag of hardware contained:
• spare thumbwheel
• two nylon tubes
• stick-on cable tie
• four allen keys
• fuse
• three M3x15 bolts
• three M£x12 bolts
• five M3x10 bolts
• fifteen M3 nuts
Dual Spiral Lightbulb Sculpturehttp://www.thingiverse.com/thing:24646
More details on challenge here:http://forums.reprap.org/read.php?282,137052
Timelapse at:https://vimeo.com/44103338
Print took 00:36:19
; generated by Slic3r 0.8.2 on 2012-06-15 at 13:03:50; layer_height = 0.3; perimeters = 2; solid_layers = 3; fill_density = 0; nozzle_diameter = 0.5; filament_diameter = 1.75; extrusion_multiplier = 1; perimeter_speed = 35; infill_speed = 60; travel_speed = 130; extrusion_width_ratio = 0; scale = 1; single wall width = 0.70mm