View allAll Photos Tagged 2ndamendment

This was my first time shooting fire dancers/spinners at night. Some post processing was required to get the results seen here.

 

I used my Nikon D600 with a Sigma 70-300mm f/4-5.6 "APO" macro lens with internal focus motor ($100 used on eBay).

 

I have a bunch of other shots of the firedancers in this set- check 'em out if'n ya like this sort of thang.

IGOLD 2018. Copyright 2018, Big Dog Productions, David K. Hobby, Photographer

This image was made from seven exposures, ranging from 1/1000 sec to 4 seconds long. The exposures were combined using Photomatix's Exposure Fusion function.

A rare purple hootie monster lurks among the trunks of the nocturnal forest.

Nikon D50

Nikon 18-55mm G "kit lens" (at 55mm)

ISO 200

f/13

45.2 seconds

This is a wonderful example of what one can expect when out and about in Lewis County, New York.

 

Photo taken in the Hamlet of Brantingham.

9 Images in Helicon Focus

 

I opened up this pack to inspect it before use, as the flash it came from is quite old. Some charge / discharge cycles on my Accucel-6 charger showed that it retains about 1,300mAh discharge capacity.

 

10 Sub-C NiCd cells in series (12 Volts).

 

Thermal probe for over-temperature protection while charging.

 

Norman part number B4126 or 811926

 

normanlights.com/battery_chargers.asp

Wayne LaPierre is CEO and the Executive Vice President of the National Rifle Association.

 

The source images for this cartoon of Wayne LaPierre are Creative Commons licensed photos from Gage Skidmore's and cm195902's Flickr photostreams, a U.S. Military - Joint Task Force Guantanamo photo, a U.S. Air Force photo and Creative Commons licensed images from plural's flickr photostream and Jeffery Love's flickr photostreams.

This was my first time shooting fire dancers/spinners at night. Some post processing was required to get the results seen here.

 

I used my Nikon D600 with a Sigma 70-300mm f/4-5.6 "APO" macro lens with internal focus motor ($100 used on eBay).

 

I have a bunch of other shots of the firedancers in this set- check 'em out if'n ya like this sort of thang.

Here's a view with the aluminum cover slid off.

 

The MW6208E USB controller chip is visible. Knowing the part numbers of the ICs inside a flash drive can help you to Google up the correct software to reprogram the drive back to actual capacity.

 

You don't want to leave the drive as-is, because any data written to it beyond the actual capacity will corrupt the drive.

 

There are two more photos in this set.

 

Please click on the following link to go to an alert page on SOSFakeFlash.com about fraudulent eBay seller garysin2008:

sosfakeflash.wordpress.com/2009/12/23/garysin2008-urgent-...

This is my Kearney & Trecker horizontal milling machine. It was made during World War II, and was presumably used to produce parts for the war effort.

 

It has been sitting in my yard for quite a few years, and is missing some parts, some of which were sold to bring new life to other old K&T mills.

 

It will soon be scrapped, unless some intrepid parts scroungers save at least some relics from the aging derelict.

This photo was made with my old Nikkor-S 50mm f/1.4 lens. It was made in 1972 or 1973. It is quite scratched, dusty and maybe even has a little fungus growing, along with damaged coatings.

 

Nonetheless, it is fun to play with. I performed a crude AI-modification to the aperture ring (I used a file). The lens now works perfectly with my Nikon D600 (full metering and focus confirmation).

Samyang / Rokinon 8mm f/3.5 fisheye lens.

The lens hood has been “shaved” to allow a nearly full circle image to be captured.

Here you can see the nut that binds the antenna to the PCB. The base of the antenna is threaded brass, making this a VERY easy mod. Just drill one hole in the plastic top cover of the transmitter, poke the antenna through the existing hole in the PCB, and tighten the nut.

 

YOU'RE DONE!

 

See the previous two photos in the set for more info.

Delaware Gun Rights rally against over-reaching gun bills

Norman LH2000 flashtube, as lit by three more of the same model tube. This one was inside my photo tent, illuminated from each side, with the backdrop blasted out to nearly pure white by the third tube.

 

Each one of these tubes can handle up to 2,400 Joules of energy, about 240 times as much as the little flashtube in your point&shoot digital or disposable film camera.

 

The LED "flash" in your smartphone works on a totally different principle- there is no easy direct comparison to a strobe, except perhaps the brightness in Lumens. This is not a measure of total light energy output, but is still interesting. Newer smartphones might have an LED with about 50 Lumens of brightness, perhaps a bit more.

 

This flashtube, on the other hand, would be WAY into the millions of Lumens, though for a far shorter duration than the LED, so the total energy (exposure) difference is not as great as implied by the vast difference in instantaneous output.

 

The very short duration of a strobe is why they're so useful for stopping motion, camera and/or subject.

This was my first time shooting fire dancers/spinners at night. Some post processing was required to get the results seen here.

 

I used my Nikon D600 with a Sigma 70-300mm f/4-5.6 "APO" macro lens with internal focus motor ($100 used on eBay).

 

I have a bunch of other shots of the firedancers in this set- check 'em out if'n ya like this sort of thang.

Oh, what fun these high quality Tamiya models are to build! Photo was shot with a Sigma 10-20mm ultra wide angle lens.

Adventures in Big Valley, California.

 

EZ's "new" stainless steel tub for hot spring soaking.

AK Hellpup 7.62x39

Pioneer Arms

Radom, Poland

I.O. Inc. Monroe, N.C.

www.centerfiresystems.com

www.uspalm.com (grip)

www.rifledynamics.com T's, Jim Fuller's Armorer's Bench video

www.tactical tailor.com cover/hat

www.gadsdenand culpeper.com U.S.Navy Jack flag patch

Historic John Jovino Gun Shop, Little Italy, NYC

This is my Clausing model 5912 engine lathe, built in 1968 or so.

 

I bought it used from a seller in SE New Hampshire in 2003, for only $600.

It shows very little wear, and has a flame-hardened bed.

 

I brought it back to Northern New York, towed behind by Dad's 1988 Isuzu Trooper II, in a 1970's vintage DIY utility trailer.

 

12.25-inch swing, 36-inches between centers.

 

It was originally equipped with a 1HP three-phase motor and a hydraulically-controlled variable-speed spindle drive. I am replacing the original drive and motor with a new three-phase 7.5HP direct-drive motor and a 480V VFD (Variable Frequency Drive).

1/11/2019 Mike Orazzi | Staff

Jim Zoppi of Jim's Collectibles & Firearms in Plainville supports Federal Democratic legislation for federal background checks on all firearm transactions.

Nikon D600

Holga HPL-N pinhole lens

40mm focal length

f/160 (.25mm aperture)

ISO 100

 

The Holga vignettes substantially on the D600's full-frame FX sensor, but I rather like the effect.

 

I've found that in full daylight at high ISO (6400 to 25,600), the D600 can do handheld shots at 1/30 sec., quite a fun thing to play with!

Where did he go? I just saw the glint of his lens a moment ago!

 

Samyang 500mm F/8 preset lens, handheld.

 

Heavily cropped from six megapixel image. I'm not much of a birder, and have not yet developed the patience and skill it takes to get close enough to a wee bird, even with a 750mm equivalent lens...

Beautiful image of my TRP

For my Non Lone Wolf Glock clients, who wanted a similar image

500mm Samyang F/8 preset lens, handheld.

My Dad's just-aquired 1983 Volkswagen Rabbit L

 

The driver seems excited!

1 2 ••• 10 11 13 15 16 ••• 79 80