View allAll Photos Tagged stud
Here we are laying out the wall studs in their approximate locations. We had marked the plates with lines where the studs will go - one every 16 inches. They should have been laid out standing on the narrow side, since that's the way they will be nailed onto the plates, but it was no big deal on this job.
The two studs with the square shoulders fit the square holes in the regulator gland to stop it rotating.
Went in my studio with Bergen and Addi, Bergen was working on school-project and I was helping him out with the studio work. He is a newbie in the studio. Addi was posing.
More to come :D
Fór með Bjögga og Adda uppà StúdÃo að hjálpa Bjögga með skólaverkefni, á meðan Addi pósaði
66705 departs from Eastleigh virtual quarry with IOA boxes for Stud farm. Shame about the graffiti attack - mind less morons. April 15 2015
vida project x, studio petrangelo, studio de fotografia, look book, moda, catalogo, campanha, estudio de fotografia, produção audiovisual, produtora audiovisual, agencia de publicidade, making off moda, making off, fotografia, vidaprojectx , studiopetrangelo, fotografia, educação, saude, video, concientização, campanha, digão rodrigo lucas petrangelo, Studio Petrangelo
Biblioteca di Città Studi al tramonto. Foto scattata in occasione della prima festa studentesca, coincidente con il giorno di apertura dell'anno accademico
I deliberated over how to put the studs in for this face for a while. I knew the bottom joist would be really long and potentially not too sturdy if I didn't get it solidly in there, so I wanted all the vertical studs screwed into it well (the screws going from the underside of the joist up into each stud.) That wasn't going to be possible if I put the joist on the frame first.
I laid the joist sideways, and lined the studs up against it on the ground, and assembled the whole thing laying down. Then I carefully stood it up into the frame and propped it up on some scrap wood. The studs didn't all quite line up (not a surprise, given the scale of this stuff.)
I finally ended up getting the jack out of the trunk of my car and putting it underneath each stud, jacking it up until the stud was snug against the frame above it, and toenailing some screws in to secure it. Lower the jack, move on. It worked remarkably well.
Presentazione in anteprima mondiale della Studio Torino Moncenisio presso il Museo dell'Automobile di Torino