View allAll Photos Tagged 3Dprinter
Fully built kit - pololus's installed. Also installed all of the endstop connectors.
Compare to the older version: www.flickr.com/photos/jabella/5316996115/in/set-721576238...
This is from Rob G: tinkerin.gs
Milwaukee Makerspace has this on loan for a few weeks...
(This is actually four photos loosely stitched together because I only had my 50mm lens.)
A stand to hold some 3D printed Olympic rings. The rings were printed out in coloured plastic and then linked together. The model for the rings can be found here: www.thingiverse.com/thing:27306
The base is printed in shiny Faberdahsery Robot Silver plastic. The model was designed in Autodesk Inventor and then 3D printed on my RepRapPro Huxley.
My favourite of the Sheffield Christmas lights this year are these 3D illuminated butterflies entitled Butterfly Transformation which feature over a 100 different lighting styles, the tallest of which is over six metres high. They were unveiled in Millennium Square during the Christmas lights switch-on and will stay there for six weeks. The butterflies were developed by academics at South China University of Technology's School of Architectural Design and have been donated by their Confucius Institute partner at Sheffield University. This installation was first exhibited at the Guangzhou International Light Festival in 2016, then at the Light Up Lancaster event in early November 2017. The exhibitions in Lancaster and Sheffield are the first time the work has been shown outside of mainland China.
He3D- Triple Extruder Reprap 3D Printer Build Area: 180x230x140mm Printing material: ABS, PLA, 1.75mm.
www.3dprintersonlinestore.com/3d-printers/he-3-d/he-3d-mu...
I didn't recognize this file, but the print quality looked good. I wish the tags said which unit printed each part.
Printed at various infills. These were stopped before being completed. .5 infill on the right, .3 on the left.
Pololu Stepper Motor Driver, relay board, stepper driver v3.3 board (for MK6 Stepstruder) and some custom cabling. I have to print some mounts and clean this up.
It also contained two filament spools:
• White ABS 1.75
• Translucent Blue PLA 1.75
Spools are smaller than usual:
• Outer diameter:
• Inner diameter:
• Weight:
A mere $250,000 each, and TechShop SF has 7 of them.
www.objet.com/3d-printers/connex/objet-connex500
Scenes from the nerve center of the 72-hour Red Bull Creation challenge at the TechShop Annex in San Francisco.
This is my father's bot, re-built. New wood, painted (inside is gloss white). Has blue and red LEDs, and the X / Y stage is printed in fluorescent red ABS.
Has a MK6 extruder, Gen 3, PSMD, etc.