57 "ALCHEMY" by Jensen Knives
57: Here I am using three #43 drill bits to re-align the holes of the tang to the corresponding holes in the top liner. These are the same drill size as I originally used to drill these, so they fit rather snug. I have then used a few clamps to secure the position. From here, I will remove the aligning drill bits.
1,405
views
0
faves
0
comments
Uploaded on November 10, 2013
57 "ALCHEMY" by Jensen Knives
57: Here I am using three #43 drill bits to re-align the holes of the tang to the corresponding holes in the top liner. These are the same drill size as I originally used to drill these, so they fit rather snug. I have then used a few clamps to secure the position. From here, I will remove the aligning drill bits.
1,405
views
0
faves
0
comments
Uploaded on November 10, 2013