wizard23
First ABS parts printed
This happens if you print ABS in too high layers and/or with a too low temperature (not sure what was the reason here we changed both the temperature and the filament width setting in the skeinforge scripts in the next run that was more successfully). Here we just took the HDPE parameters but extruded ABS instead. You can easily peel off layer by layer. While this is no good for objects it would be a good choice for support material as adrian noted somewhere on the forums (i think).
First ABS parts printed
This happens if you print ABS in too high layers and/or with a too low temperature (not sure what was the reason here we changed both the temperature and the filament width setting in the skeinforge scripts in the next run that was more successfully). Here we just took the HDPE parameters but extruded ABS instead. You can easily peel off layer by layer. While this is no good for objects it would be a good choice for support material as adrian noted somewhere on the forums (i think).