View allAll Photos Tagged microcontrollers
Dorkboard assembly - Repeating for the 4-pin header. Clip off a 4-pin section of male header and mount it on the bottom of the board. Insert the short pins from the bottom and solder them on the top side.
Arduino is een opensource-computerplatform dat is opgebouwd rond de ATmega168-microcontroller van Atmel en het softwareontwikkelplatform Processing. Dit platform is bedoeld voor hobbyisten, artiesten, kunstenaars en iedereen die geïnteresseerd is in het maken en ontwerpen van slimme en creatieve objecten die kunnen reageren op hun omgeving.
Met Arduino is het mogelijk apparaten en objecten te creëren die reageren op hun omgeving door middel van digitale en analoge inputsignalen. Op basis van deze input kan een Arduinoschakeling autonome actie initiëren door het afgeven van digitale en analoge outputsignalen. Input kan bijvoorbeeld worden gegenereerd door schakelaars, lichtsensoren, bewegingsmeters, afstandsmeters, temperatuursensoren, of op basis van commando's afkomstig van internet, een radiomodule of een ander apparaat met een seriële interface. Outputsignalen kunnen bijvoorbeeld motoren, lampjes, pompjes en beeldschermen aansturen, maar ook input genereren voor een andere Arduinomodule.
Daarnaast bestaan ook zogenaamde "shields". Deze integreren vaak verschillende sensoren en modules in één printplaat. Deze kan dan gemakkelijk op de Arduino aangesloten worden door hem te plaatsen op de input-/outputpinnen van de Arduino. Vele van deze shields worden verkocht als kit en dienen dus zelf nog gesoldeerd te worden. Veelvoorkomend zijn de wifi- en gps-kits. Naast deze kits kan ook een ProtoShield gekocht worden die dienstdoet als breadboard om op te experimenteren.
Turned a Rubbermaid food storage container into a case to carry my Arduino in my bag on my bicycle.
For Bread Bike Blog
The CNC router is a large, horizontal milling machine that can cut many types of materials, including plastics, Delrin and other non-ferrous materials. This particular machine handles a full sheet of 4’ x 8’ material and uses a 10-tool changer to pick the right cutter for the job. The primary use of this machine is to build our Parallax DIY solar panel products.
My standard LED status indicator for the Jeenode. More details at www.ka1kjz.com/787/a-standard-led-indicator-for-jeenodes/
Dorkboard assembly - Clip off a 5-pin section of male header. Mount the 5-pin header on the top side of the board. The shorter side of the pins will point down, the longer side of the pins will face up.
The pin on the microcontroller that connects to CS on the EEPROM has been lifted off the board. A relay is used to connect or disconnect the signal. A 3.3Kohm resistor is connected between the EEPROM's CS and GND so the EEPROM stays disabled when the connection to the microcontroller is broken.
Foto von Jan Kraus
An unserem Code&Play Stand konnte an drei Tagen ein buntes Workshop-Angebot wahrgenommen werden. Mit dabei waren:
senseBox, Junge Tüftler, NaWiTex-Schülerlabor, Technologiestiftung Berlin, Open Knowledge Foundation, Infosphere Aachen, Coder Dojos, Creative Gaming und das Game Science Center!