post-apocalyptic research institute
post-apocalyptic research institute
Printing Minecraft models on a MakerBot Replicator 2
During OHM2013, we tested printing a Minecraft model on a MakerBot Replicator 2. Turned out much better than we had expected! The model was exported with Mineways with the standard size of 2mm per block (edge length). For the print, it was resized to 60%.
3,653
views
0
faves
0
comments
Uploaded on August 9, 2013
Taken on August 3, 2013
Printing Minecraft models on a MakerBot Replicator 2
During OHM2013, we tested printing a Minecraft model on a MakerBot Replicator 2. Turned out much better than we had expected! The model was exported with Mineways with the standard size of 2mm per block (edge length). For the print, it was resized to 60%.
3,653
views
0
faves
0
comments
Uploaded on August 9, 2013
Taken on August 3, 2013