Prometheus Titan Guide

To make the trigger mechanism, use the trigger rod from the front gun.

 

First, cut the plastic piece off of the release rod for the titan air tank.

 

Then cut the rod down so that the rear of the upper portion of the rod lines up with the metal ring on the release rod for the air tank. Make sure the ring is as far back as it can go. You will need to trim the groove in the longshot rod so that it fits neatly over the titan release rod.

 

Once you confirm that the slot fits over the rod neatly, put a small amount of plastic epoxy into the slot and put it in place on the rod.

 

To attach the rod to the trigger, use plastic epoxy to join the rod and the trigger. Make sure that the epoxy does not spill over and seal the trigger to the grip.

Done