1:72 Supermarine Spitfire Mk. XVIe Trop (Type 361); aircraft "١٥٤ ﻞ/L 154" of 2nd Squadron, Lebanese Air Force (LAF) (القوات الجوية اللبنانية‎/Al Quwwat al-Jawwiya al-Lubnaniyya); Rayak Air Base, 1951 (Whif/Heller kit conversion)

+++ DISCLAIMER +++

Nothing you see here is real, even though the conversion or the presented background story might be based historical facts. BEWARE!

 

Some background:

The Supermarine Spitfire is a British single-seat fighter aircraft that was used by the Royal Air Force and many other Allied countries during and after the Second World War. The Spitfire was built in many variants, using several wing configurations, and was produced in greater numbers than any other British aircraft.

 

The Spitfire was designed as a short-range, high-performance interceptor aircraft by R. J. Mitchell, chief designer at Supermarine Aviation Works (which operated as a subsidiary of Vickers-Armstrong from 1928). In accordance with its role as an interceptor, Mitchell designed the Spitfire's distinctive elliptical wing to have the thinnest possible cross-section; this thin wing enabled the Spitfire to have a higher top speed than several contemporary fighters, including the Hawker Hurricane.

 

It was the only British fighter to be in continuous production throughout World War II, and remained in service with several air forces around the world for several years. One of its post-war operators was the Lebanese Air Force, or Al Quwwat al-Jawwiya al-Lubnaniyya (لقوات الجوية اللبنانية‎).

The Lebanese Air Force was established in 1949 under the command of then-Lieutenant Colonel Emile Boustany who later became commander of the army. Soon after its establishment, a number of planes were donated by the British, French, and Italian governments, with additional planes donated by Britain and Italy later that same year.

 

Britain donated 4 Percival Prentices, 2 World War II-era Percival Proctors and seven trpocailized Supermarine Spitfires (six Mk. XVIe and one TR.8 two-seater), while Italy donated 4 Savoia-Marchetti SM.79 bombers which were mainly used for transportation.

 

The Mk XVI Spitfire was a WWII design, and the last variant powered by a Merlin engine and based on the original, sleek fuselage. It was basically the same as the Mk IX, except for the engine, a Merlin 266. The Merlin 266 was the Merlin 66 and was built under licence in the USA by the Packard Motor Company. The "2" was added as a prefix in order to avoid confusion with the engines, as they required different tooling.

 

All Mk XVI aircraft produced (a total of 1,054 Mk XVIs left Castle Bromwich) were of the Low-Altitude Fighter (LF) variety. This was not determined by the length of the wings (clipped wings were fitted to most LF Spitfires), but by the engine, which had been optimised for low-altitude operation. All production Mk XVIs had clipped wings for low altitude work and were fitted with the rear fuselage fuel tanks with a combined capacity of 75 gal. Many XVIs featured cut-down rear fuselages with bubble canopies. On these aircraft the rear fuselage tank capacity was limited to 66 gal.

 

Because of a slightly taller intercooler and rearranged accessories on the Packard Merlins a new, bulged upper cowling was introduced, a detail that also appeared on late production IXs. For the service in the Middel East region the Lebanese machines received dust filters which considerably changed the aircraft's silhouette.

 

Armament consisted of two 20 mm Hispano II cannons - each with 120 rpg - and two 0.50 calibre Browning machine guns - each with 250 rpg. 1 × 500 lb (227 kg) bomb could be carried underneath the centre rack, and 1 × 250 lb (114 kg) bomb could be slung under each wing. As a special feature, the wing hardpoints of the Lebanese Spitfires were "wet" so that slipper tanks with 24 gal. each could be carried, compensating for the reduces rear fuselage tank due to the bubble canopy's lowered dorsal spine.

 

The Lebanese Spitfires only saw a short service, since in 1953, jet fighters were introduced when 16 de Havilland Vampire jets were received, and the first Hawker Hunters arrived in 1959, which replaced the obsolete Spitfires. This initial Hunter batch was followed by more Hunters through 1977.

 

In 1968, 12 Mirage IIIELs were delivered from France but were grounded in the late 1970s due to lack of funds. In 2000, the grounded Mirages were sold to Pakistan, and four Hunters were even revived in 2008 and served until 2014.

 

 

General characteristics:

Crew: one pilot

Length: 29 ft 11 in (9.12 m)

Wingspan: 36 ft 10 in (11.23 m)

Height: 11 ft 5 in (3.86 m)

Wing area: 242.1 ft2 (22.48 m2)

Airfoil: NACA 2209.4(tip)

Empty weight: 5,065 lb (2,297 kg)

Loaded weight: 6,622 lb (3,000 kg)

Max. takeoff weight: 6,700 lb (3,039 kg)

 

Powerplant:

1× Rolls-Royce Merlin 60 supercharged V12 engine,

rated at 1.470 hp (1.096 kW) at 9.250 ft (2.820 m)

 

Performance:

Maximum speed: 370 mph, (322 kn, 595 km/h)

Combat radius: 410 nmi (470 mi, 760 km)

Ferry range: 991 nmi (1,135 mi, 1,827 km)

Service ceiling: 36,500 ft (11,125 m)

Rate of climb: 2,600 ft/min (13.2 m/s)

Wing loading: 27.35 lb/ft2 (133.5 kg/m²)

Power/mass: 0.22 hp/lb (0.36 kW/kg)

 

Armament:

2x 20mm Hispano Mk II cannon (120 RPG)

2x .5 in Browning machine guns (250 RPG)

Three hardpoints (1 ventral, 1 under each outer wing) for up to 1.000 lb (454 kg).

 

 

The kit and its assembly:

This whif is based on a simple idea: how did Lebanon's Air Force start? Small countries make a good whif playground, and I guess that nobody has the Lebanon on his/her list...?

Another factor was that I had some Austrian roundels left in store that could, with a green dot, easily be turned into Lebanese markings. So the theme was quickly settled, but the details take some preparation time, so the idea lingered for some time.

 

After some legwork I deemed a simple Spitfire with a dust filter worthy as an initial aircraft, and the respective Hobby Boss kit of a Spitfire Mk. VB in the stash came handy.

But somehow this was a bit dull, and at the inception of the Lebanon Air Force there were better option available than an early Mk. V. I still wanted a sleek, Merlin-powered Spitfire variant, though, and eventually settled for the Mk. XVI - with its clipped wings and the bubble canopy it has a very distinctive look.

 

When a "1 Week group Build" at whatifmodelers.com in the Easter Week 2015 was announced, I took this occassion to build the Lebanese Spitfire.

 

By that time I already had a basis kit at hand (Heller's Spitfire XVI) as well as some donation parts and decals.

Work was strightforward, the Heller kit was built almost OOB. It's a rather old model kit, with raised panel lines, but good detail. The material is thin, so the built item lacks some structural stability! On the other side, this makes some minor mods really easy: I lowered the flaps and moved the tail rudders slightly off of neutral position. I also opened the cockpit "door" on the left side for later static display, even though the cockpit itself was left OOB. It's a bit "flat", but for the kit's age it's pretty good, and the injected canopy is crystal clear and fits perfectly.

 

I had some major woes concerning the fit for the forward fuselage, and even more when I tried to mate wings and fuselage: there was a 1mm gap(!) on both sides that had to be bridged with putty, and the thin and flexible material did help much...

 

Other mods concern the propeller (added a styrene tube and a metal axis for free spin), the radiators (these are molded into the lower wings - sounds horrible, but is made very well and thin, I just added some foamed styrene inside as protective mesh because OOB there's just a blank "box" inside) and the kit received a dust filter - a resin piece taken from a Pavla conversion set for Hawker Hurricanes.

 

 

Painting and markings:

While a donated RAF Spitfire would certainly have carried a desert paint scheme in Dark Earth/Mid Stone/Azure Blue or a late WWII Dark Green/Ocean Grey/Light Sea Grey livery I settled for something more individual and effective for the rugged Levantine terrain.

In this case I went for the rarely used RAF 'Tropical Scheme' in Mid Stone/Dark Green from above and with Mediterrenean Blue undersides.

 

The pattern itself is standard RAF, the upper cammo taken down onto the dust filter's flanks was taken over from RAAF Spitfires during WWII (RAF aircraft would carry a higher waterline, with the filter painted completely in the lower surface's tone). Basic paints are RAF Dark Green from Modelmaster and Humbrol 84 (RAF Mid Stone) - rather authentic. But I used Humbrol 87 (Steel Grey) for the undersides - it's rather intense and has a greenish hue, and by far not as dark as the typical RAF Azure Blue or PRU Blue.

 

Interior surfaces were painted in RAF Cockpit Green (Modelmaster Authentic), while the landing gear and its wells were kept in Aluminum Dope (Humbrol 56).

 

Decals/markings were puzzled together and improvised. The Lebanese roundels are actually Austrian national markings into which a dark green dot has ben added manually... the fin flash and the roman/arabic codes come from an Xtradecal aftermarket sheet.

 

Beyond these basic markings I did not add anything flashy - in 1951 things were rather simple,

The kit received a light shading and some dry painting with light grey, plus a light black ink wash. Soot/exhaust stains were created with grinded graphite and around the engine some leaked oil was added with Tamiya's "Smoke", and everything was sealed under a coat of matt acrylic varnish.

 

 

I'll admit it's not a spectacular whif, and overall rather simple concerning build and painting. But a proud addition to whatifmodelers.com's "! Week Group Build", even though this was already finished in just three days from sprues to beauty pics...

 

Done