Franz Component
By loosening the kip lever on top of the pusher unit, the plywood panel can be set at any angle. There is no built-in mechanism provided to square the face of the plywood panel perpendicular to the travel of the sliding table. The easiest way to square the pusher unit to the blade is to pull over the rip fence, and use the rip fence as a registration stop before clamping down on the kip lever. One complaint I had is that the kip lever is too low to clear the handle when it's rotated fully. I rectified this by adding additional washers under the kip lever.
Franz Component
By loosening the kip lever on top of the pusher unit, the plywood panel can be set at any angle. There is no built-in mechanism provided to square the face of the plywood panel perpendicular to the travel of the sliding table. The easiest way to square the pusher unit to the blade is to pull over the rip fence, and use the rip fence as a registration stop before clamping down on the kip lever. One complaint I had is that the kip lever is too low to clear the handle when it's rotated fully. I rectified this by adding additional washers under the kip lever.