Mixel Barbell
From the feedback I've reveived on my cannon ball w/pin, it appears there is an inrerest in seeing it used in a mixel-ball hub (#14704 "Plate, Modified 1 x 2 with Ball Receptacle Small on Side"), but with some alterations.
Some have suggested I pierce the ball, to allow any length of bar to attach. However, without a bar molded tot the ball, you can't remove the ball from the ball receptacle without a knife!
So, I'm wondering if a barbell design might work, and if so, what length of bar would be most useful (expressed in terms of plate thicknesses)
Your thoughts?
Mixel Barbell
From the feedback I've reveived on my cannon ball w/pin, it appears there is an inrerest in seeing it used in a mixel-ball hub (#14704 "Plate, Modified 1 x 2 with Ball Receptacle Small on Side"), but with some alterations.
Some have suggested I pierce the ball, to allow any length of bar to attach. However, without a bar molded tot the ball, you can't remove the ball from the ball receptacle without a knife!
So, I'm wondering if a barbell design might work, and if so, what length of bar would be most useful (expressed in terms of plate thicknesses)
Your thoughts?