Mega Tripod (printing in progress)
Another 4x print test of the BrickArms tripod in PLA. This time, I exported the tripod as a single item (no detachable legs). There is some separation on the long leg as it wanted to lift off of the bed as the print progresses.
The short leg does not need supports, since it has a fairly steep angle. The Cura software uses a 60 degree threshold, as a default.
Print height is set at .06mm
Mega Tripod (printing in progress)
Another 4x print test of the BrickArms tripod in PLA. This time, I exported the tripod as a single item (no detachable legs). There is some separation on the long leg as it wanted to lift off of the bed as the print progresses.
The short leg does not need supports, since it has a fairly steep angle. The Cura software uses a 60 degree threshold, as a default.
Print height is set at .06mm