24c1963
Simplift3D Robox QuickFill
These are some screenshots taken from the Simplify3D QuickFill profile I've been working on for a while now, which pushes the QuickFill head further, and using the 0.8mm nozzle for 0.2mm layer height prints, saves quite a bit of time over the same using a 0.3mm nozzle. It's also intesting doing a mix and match combo too, 0.8mm infill, 0.3 for the externals or whatever tickles your imagination.
Simplift3D Robox QuickFill
These are some screenshots taken from the Simplify3D QuickFill profile I've been working on for a while now, which pushes the QuickFill head further, and using the 0.8mm nozzle for 0.2mm layer height prints, saves quite a bit of time over the same using a 0.3mm nozzle. It's also intesting doing a mix and match combo too, 0.8mm infill, 0.3 for the externals or whatever tickles your imagination.