LANE Boys RC
P1260552
The micro-controller has been soldered onto the 3.3V test pad. This provides mechanical stability for the chip, no glue necessary.
Enamel wire was used to connect to a nearby ground test pad and the servo signals directly on the output connectors.
The servo signal output pin on the battery connector terminal of the receiver is not connected to any hardware, so unlike for the HKR3000 receiver no modification was needed.
P1260552
The micro-controller has been soldered onto the 3.3V test pad. This provides mechanical stability for the chip, no glue necessary.
Enamel wire was used to connect to a nearby ground test pad and the servo signals directly on the output connectors.
The servo signal output pin on the battery connector terminal of the receiver is not connected to any hardware, so unlike for the HKR3000 receiver no modification was needed.