morris_marlin
M54 block modification
piece added in on cylinder 3. I messed up on this slightly as I cleaned up the top welds to get everything nice and flat then later in the day came back and added a bit more weld underneath. This caused the upper surface to pull downwards by a fraction of a mm. I may just relevel with some metal epoxy to save causing extra problems by getting the welder on it again.
M54 block modification
piece added in on cylinder 3. I messed up on this slightly as I cleaned up the top welds to get everything nice and flat then later in the day came back and added a bit more weld underneath. This caused the upper surface to pull downwards by a fraction of a mm. I may just relevel with some metal epoxy to save causing extra problems by getting the welder on it again.