406 Vette
Edelbrock Victor Jr.
My old intake cleaned up with some aluminum trailer acid.The right front and left rear long turn runner lined up past the Dart 215 port, so I had the intake welded to fill the mismatch and I blended and gasket matched all the ports.All of the center dividers/ports lined up very close except on the right front and left rear,and I don't know exactly why the mismatch on just each corner?{Valve guide spacing is moved from stock}I'm sure if I got a new Dart intake it would bolt on and match,it was not in the budget so out came the grinder.
www.hotrod.com/techarticles/engine/hrdp_0802_chevy_intake...
Carb Pad Height:5.04"
Plenum Depth:3.91"
The spacer combo used is 1.850" thick,changing the carb pad height to 6.89" and the plenum depth to 5.76".
Edelbrock Victor Jr.
My old intake cleaned up with some aluminum trailer acid.The right front and left rear long turn runner lined up past the Dart 215 port, so I had the intake welded to fill the mismatch and I blended and gasket matched all the ports.All of the center dividers/ports lined up very close except on the right front and left rear,and I don't know exactly why the mismatch on just each corner?{Valve guide spacing is moved from stock}I'm sure if I got a new Dart intake it would bolt on and match,it was not in the budget so out came the grinder.
www.hotrod.com/techarticles/engine/hrdp_0802_chevy_intake...
Carb Pad Height:5.04"
Plenum Depth:3.91"
The spacer combo used is 1.850" thick,changing the carb pad height to 6.89" and the plenum depth to 5.76".