nfisher1226
Dry fit, back
Dry fit of all major components, back side.
Back plate is (l-r) fuse holder, IEC power cord plug, impedence switch (8 or 16 ohms) and twin output jacks. To be installed are the test points for the bias supply as well as the bias pot itself.
On top of the amp we have the two el84 output tubes (currently Sovtek but I plan to get some JJ's) and the two 12ax7 preamp tubes. The PT is laying down to the far left, OT is nestled between PT and cap board.
For the bias pot, I plan on making a U bracket to mount the pot with the slotted shaft facing towards the back plate. A pilot hole will provide access to bias the amp without removing the chassis from it's cabinet.
Dry fit, back
Dry fit of all major components, back side.
Back plate is (l-r) fuse holder, IEC power cord plug, impedence switch (8 or 16 ohms) and twin output jacks. To be installed are the test points for the bias supply as well as the bias pot itself.
On top of the amp we have the two el84 output tubes (currently Sovtek but I plan to get some JJ's) and the two 12ax7 preamp tubes. The PT is laying down to the far left, OT is nestled between PT and cap board.
For the bias pot, I plan on making a U bracket to mount the pot with the slotted shaft facing towards the back plate. A pilot hole will provide access to bias the amp without removing the chassis from it's cabinet.