DaveH6
Building jig to establish the dead rise.
This floor is level...no shimming needed under the building jig to get it level.
Knowing how twisty dimensional lumber can be, I made"2x4s" out of ripped 3/4" plywood. These four pieces tie the three bulkheads together. When I rolled the hull over I was very pleased with how flat and symetrical the aft sections were. I believe my dilligence on constructing the building frame paid off.
Building jig to establish the dead rise.
This floor is level...no shimming needed under the building jig to get it level.
Knowing how twisty dimensional lumber can be, I made"2x4s" out of ripped 3/4" plywood. These four pieces tie the three bulkheads together. When I rolled the hull over I was very pleased with how flat and symetrical the aft sections were. I believe my dilligence on constructing the building frame paid off.