Jonathan Merritt
Jonathan Merritt
Load cell WIP
This is the load cell blank with three features machined on it: a tapped hole and two bored holes.
The bored holes were done on my Sieg C4 lathe, using a tool bit that I ground myself. They are M16, bored out from an M10 starter hole, which was drilled.
Tolerances are +/- 0.05 mm.
428
views
0
faves
0
comments
Uploaded on August 30, 2009
Taken on August 30, 2009
Load cell WIP
This is the load cell blank with three features machined on it: a tapped hole and two bored holes.
The bored holes were done on my Sieg C4 lathe, using a tool bit that I ground myself. They are M16, bored out from an M10 starter hole, which was drilled.
Tolerances are +/- 0.05 mm.
428
views
0
faves
0
comments
Uploaded on August 30, 2009
Taken on August 30, 2009