beeElectronics
To support the paper and electronics I backed the entire sheet with book board. I pieced the board with an awl to pass the electrically conductive thread through from each bee/sensor and to either end of the speaker spiral. Each bee sensor is wired to a DIO pin on the Arduino wave shield, and the speaker to the speaker output and speaker ground.
517
views
0
faves
0
comments
Uploaded on May 31, 2015
Taken on May 28, 2015
beeElectronics
To support the paper and electronics I backed the entire sheet with book board. I pieced the board with an awl to pass the electrically conductive thread through from each bee/sensor and to either end of the speaker spiral. Each bee sensor is wired to a DIO pin on the Arduino wave shield, and the speaker to the speaker output and speaker ground.
517
views
0
faves
0
comments
Uploaded on May 31, 2015
Taken on May 28, 2015