ORION_brick
In Memory
...of the saddest death in Star Wars.
This is my first model in a LONG time that was actually built irl before it was realized digitally. I had enough spare parts at uni to make one half of the helmet. Because of this, I can actually comment on the real-world buildability, which is to say that it is actually a fairly stable and heafty beast. I tried my best to match the stud/smooth mixture of the official SW helmet sets with the smooth areas pulling focus to specific aspects of the design (the visor and the breathing tube things).
The instructions are available here on rebrickable. The red marking is a custom sticker that I will post eventually when I figure out how. I actually came up with a very nice SNOT solution but it only looked good from the front and so had to be scrapped.
In Memory
...of the saddest death in Star Wars.
This is my first model in a LONG time that was actually built irl before it was realized digitally. I had enough spare parts at uni to make one half of the helmet. Because of this, I can actually comment on the real-world buildability, which is to say that it is actually a fairly stable and heafty beast. I tried my best to match the stud/smooth mixture of the official SW helmet sets with the smooth areas pulling focus to specific aspects of the design (the visor and the breathing tube things).
The instructions are available here on rebrickable. The red marking is a custom sticker that I will post eventually when I figure out how. I actually came up with a very nice SNOT solution but it only looked good from the front and so had to be scrapped.