Stan Wellbach
Stan Wellbach
Welding on the Spring Pads
The back axle input shaft must rise to the gearbox at 4 degrees, to get a reasonable drive shaft alignment. Here the axle is being set to the right angle while resting on trestles that have been levelled up with shims.
96
views
0
faves
0
comments
Uploaded on June 23, 2017
Taken on March 7, 2017
Welding on the Spring Pads
The back axle input shaft must rise to the gearbox at 4 degrees, to get a reasonable drive shaft alignment. Here the axle is being set to the right angle while resting on trestles that have been levelled up with shims.
96
views
0
faves
0
comments
Uploaded on June 23, 2017
Taken on March 7, 2017