3 of 3 Making a PureNeemoXS fit a Middie

Okay so LOTS of people ask me how I put my Middies on a Pure Neemo XS.

This is how I did it.

I AM NOT a customizer and most likely there are other ways to do this, but as so many people have asked I thought I would show y'all.

 

Please excuse the poor focus and the junk on the table. I took these shots a few weeks ago for a friend.

 

 

Picture 3 Once in place I attached the 'shell' that had been around the Middie body neck piece, over the bead. The bead is to substitute the bobble on the end of the Middie body.

 

This means the head will still turn and tilt without having to adapt the inside of the Middie head at all.

 

If you do not like how it looks you can replace the old body without any problems and with just the loss of a Pure Neemo XS body.

 

I'm pretty sure if you found a different doll body you could use this method.

 

***The heads can be quite loose and may turn a lot if the bead isn't big enough.. I think mine was 11mm.. I think I tried to find one the same size as the bobble on the Middie body.. but as I have mentioned before I did the converting several weeks ago and cannot remember precisely.

 

Hope this helps :)

 

*******DISCLAIMER******

 

I AM NOT A CUSTOMIZER AND IF THIS DOES NOT WORK I TAKE NO RESPONSIBILITY. LIKEWISE IF YOU SEVER A FINGER OR POKE OUT YOUR EYE WHILE ATTEMPTING THIS I TAKE NO RESPONSIBILTY AND WILL NOT CONTRIBUTE TO THE COSTS OF A BIONIC FINGER OR TERMINTAOR STYLE BEADY RED EYE.

Done