jonner
Quick and dirty Moxon vise
Made from a pair of press screws (www.rockler.com/9-press-screw) and 2x6 construction lumber. I may try to use better wood in the future, but even with low-quality wood it makes a huge difference in working with wider boards. It will hold a board 24" wide. (That may actually be a bit too long since I'll rarely work with something that wide, and the screws are often a bit too far away from normal-sized boards, so the front vice jaw has a tendency to bend a bit).
Cutting dovetails in this vice is *so* much nicer than using my cheap and crappy workbench vice. I don't need to move the board from side to side on the vice. The full width of the board is supported firmly, and I can cut everything at once without moving the board. I should have made one of these long ago.
Quick and dirty Moxon vise
Made from a pair of press screws (www.rockler.com/9-press-screw) and 2x6 construction lumber. I may try to use better wood in the future, but even with low-quality wood it makes a huge difference in working with wider boards. It will hold a board 24" wide. (That may actually be a bit too long since I'll rarely work with something that wide, and the screws are often a bit too far away from normal-sized boards, so the front vice jaw has a tendency to bend a bit).
Cutting dovetails in this vice is *so* much nicer than using my cheap and crappy workbench vice. I don't need to move the board from side to side on the vice. The full width of the board is supported firmly, and I can cut everything at once without moving the board. I should have made one of these long ago.