Drenaline
Saiga AK-47 with AFG Installed
Steps to Install: 1) Loosen the two screws at the bottom of the handguard. 2) With a screw driver and a hammer, tap the front handguard lightly so it loosens from the receiver. 3) Slide it off and place the Magpul rails centered on the handguard (I used a 6 inc. + 1 inch piece) 4) Place the AFG on the rails and position it over the handguard. 5) drill in the holes on the two exposed holes (this ensures the AFG is lined up on the two pieces 6) Use a dremel to remove the rib in the center on the other side 7) Add the screws and the nut to secure the rails. 8) Remove the AFG and drill the other two holes. 9) Use Dremel again to allow remove the respective "rib". 10) Add screws and tighten. 11) Position AFG to your liking and tighten. 12) Reinstall handguard (slightly tap it in) and tighten screws
Saiga AK-47 with AFG Installed
Steps to Install: 1) Loosen the two screws at the bottom of the handguard. 2) With a screw driver and a hammer, tap the front handguard lightly so it loosens from the receiver. 3) Slide it off and place the Magpul rails centered on the handguard (I used a 6 inc. + 1 inch piece) 4) Place the AFG on the rails and position it over the handguard. 5) drill in the holes on the two exposed holes (this ensures the AFG is lined up on the two pieces 6) Use a dremel to remove the rib in the center on the other side 7) Add the screws and the nut to secure the rails. 8) Remove the AFG and drill the other two holes. 9) Use Dremel again to allow remove the respective "rib". 10) Add screws and tighten. 11) Position AFG to your liking and tighten. 12) Reinstall handguard (slightly tap it in) and tighten screws