Kyla Overbay
Oopsies
So I was about nine tenths of the way through building the corner wall section when I realized it was off by one stud, along both the x and y planes. Ha! I finished it anyway. I'm a little relieved, as one more stud should give me more room for correct sizing of the stripes and possibly add some strength. I was a wee bit concerned that the entire upper two thirds is connected to one stud!
I posted this because, well, it was a fair amount of head scratching and I am pleased with how it came out. The gray corner angled plates aren't showing how much smushing they'll actually need to fit in there... but I think it'll work.
Just as an aside, the middle bits of the straight wall segments will also need a little tweaking!
Cheers
Oopsies
So I was about nine tenths of the way through building the corner wall section when I realized it was off by one stud, along both the x and y planes. Ha! I finished it anyway. I'm a little relieved, as one more stud should give me more room for correct sizing of the stripes and possibly add some strength. I was a wee bit concerned that the entire upper two thirds is connected to one stud!
I posted this because, well, it was a fair amount of head scratching and I am pleased with how it came out. The gray corner angled plates aren't showing how much smushing they'll actually need to fit in there... but I think it'll work.
Just as an aside, the middle bits of the straight wall segments will also need a little tweaking!
Cheers