aad.born
auto-rdf MIMC 2464_df_2
MIMC Marconi's automatic radio directionfinder,
one of the many "LODESTAR" versions.
also one of the best RDF sets at its time.
Easy to operate, manually and automatically. Gyro stabilized.
Just switch "ON" then tune for the desired beacon and its "relative" and/or "true" bearing show up immediately !
Tuning dial at the left, "null indicator" in the middle, servo motor driven pointer shows the obtained RDF bearings at the scales on the right.
Radio direction finding:
the first system of radio navigation was the Radio Direction Finder, or RDF.
By tuning in a radio station and then using a directional antenna, one could determine the
direction to the broadcasting antenna.
A second measurement using another station was then taken.
Using triangulation, the two directions can be plotted on a map where their intersection reveals
the location of the navigator.
Commercial AM radio-stations can be used for this task due to their long range and high power.
Strings of low-power radio beacons were also set up specifically for this task, especially along coasts, near harbors and airports.
Early RDF systems normally used a loop antenna, a small loop of metal wire that is mounted so it can be rotated around a vertical axis.
At most angles the loop has a fairly flat reception pattern, but when it is aligned perpendicular to the station the signal received on one side of the loop cancels the signal in the orhter, thus producing a sharp drop n reception.
This is known as the "null"
By rotating the loop and looking for the angle of the "null" , the relative bearing of the station can be determined.
Loop antennas could be seen on most pre-1950s aircraft and pre-90s ships.
auto-rdf MIMC 2464_df_2
MIMC Marconi's automatic radio directionfinder,
one of the many "LODESTAR" versions.
also one of the best RDF sets at its time.
Easy to operate, manually and automatically. Gyro stabilized.
Just switch "ON" then tune for the desired beacon and its "relative" and/or "true" bearing show up immediately !
Tuning dial at the left, "null indicator" in the middle, servo motor driven pointer shows the obtained RDF bearings at the scales on the right.
Radio direction finding:
the first system of radio navigation was the Radio Direction Finder, or RDF.
By tuning in a radio station and then using a directional antenna, one could determine the
direction to the broadcasting antenna.
A second measurement using another station was then taken.
Using triangulation, the two directions can be plotted on a map where their intersection reveals
the location of the navigator.
Commercial AM radio-stations can be used for this task due to their long range and high power.
Strings of low-power radio beacons were also set up specifically for this task, especially along coasts, near harbors and airports.
Early RDF systems normally used a loop antenna, a small loop of metal wire that is mounted so it can be rotated around a vertical axis.
At most angles the loop has a fairly flat reception pattern, but when it is aligned perpendicular to the station the signal received on one side of the loop cancels the signal in the orhter, thus producing a sharp drop n reception.
This is known as the "null"
By rotating the loop and looking for the angle of the "null" , the relative bearing of the station can be determined.
Loop antennas could be seen on most pre-1950s aircraft and pre-90s ships.